R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

128
<Sysname> display cwmp configuration
CWMP is enabled.
ACS URL :http://www.acs.com:80/acs
ACS username :newname
Inform enable status :disabled
Inform interval :600s
Inform time :none
Wait timeout :30s
Reconnection times :Unlimited
Source IP interface :none
Table 30 Command output
Field Descri
p
tion
CWMP is Status of CWMP, including enabled and disabled.
ACS URL URL of the ACS. It is displayed as null if not configured.
ACS username
Authentication username for connecting to the ACS. It is displayed
as null if not configured.
Inform enable status Enabled/disabled status of periodical sending of Inform messages.
Inform interval Interval between sending Inform messages.
Inform time
Date and time at which an Inform message will be sent. It is
displayed as null if not configured.
Wait timeout
Close-wait timer. It sets how long the connection to the ACS can be
idle before it is shut down. If no data has been transmitted over the
connection before the timer expires, the CPE disconnects the
connection to the ACS.
Reconnection times Number of attempts the CPE can make to retry a connection.
Source IP interface
Interface connecting to the ACS on the CPE. You can set this
interface with the cwmp cpe connect interface command.
display cwmp status
Use display cwmp status to display the current status of CWMP.
Syntax
display cwmp status [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
2: System level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.