R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

218
Eth1/2 2 100 2 128 1000 Determine Active
Table 46 Command output
Field Descri
p
tion
sFlow Version
sFlow has the following versions:
• 4—sFlow version 4.
• 5—sFlow version 5.
sFlow Global Information Global sFlow information.
Agent
IP address of the sFlow agent:
• CLI—Manually configured IP address.
• Auto—Automatically configured IP address.
Source Address Source IP address of sFlow packets.
Collector Information sFlow collector information.
ID sFlow collector ID.
IP sFlow collector IP address.
Port sFlow collector port.
Aging
Remaining lifetime of the sFlow collector. If the sFlow collector never ages out,
this field displays N/A.
Size Maximum length of the sFlow data portion in an sFlow packet.
Description Description of the sFlow collector.
sFlow Port Information Information about the sFlow enabled ports.
Interface sFlow enabled interface.
CID ID of the target collector, for receiving the counter sampling data.
Interval(s) Counter sampling interval, in seconds.
FID ID of the target collector for receiving the flow sampling data.
MaxHLen Maximum copied length of a sampled packet.
Rate Packet sampling interval.
Mode Packet sampling mode: Determine.
Status
Status of the sFlow-enabled port:
• Suspend—Port is down.
• Active—Port is up.
sflow agent
Use sflow agent to configure an IP address for the sFlow agent.
Use undo sflow agent to remove the configured IP address.
Syntax
sflow agent { ip ip-address | ipv6 ipv6-address }
undo sflow agent { ip | ipv6 }