R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

229
apply poe-profile interface
Use apply poe-profile interface to apply a PoE configuration file to a range of PoE interfaces.
Use undo apply poe-profile interface to remove a PoE configuration file from a range of PoE interfaces.
Syntax
apply poe-profile { index index | name profile-name } interface interface-range
undo apply poe-profile { index index | name profile-name } interface interface-range
Views
System view
Default command level
2: System level
Parameters
index index: Specifies a PoE configuration file by its index number in the range of 1 to 100.
name profile-name: Specifies a PoE configuration file by its name, a string of 1 to 15 characters.
interface-range: Specifies a range of Ethernet interfaces in the form of interface-type interface-number
[ to interface-type interface-number ], where interface-type interface-number represents the interface type
and interface number. The start interface number must be smaller than the end interface number. If an
interface in the specified range does not support PoE, it is ignored when the PoE configuration file is
applied.
Examples
# Apply the PoE configuration file named forIPphone to PoE interface GigabitEthernet 1/1.
<Sysname> system-view
[Sysname] apply poe-profile name forIPphone interface gigabitethernet 1/1
# Apply the PoE configuration file with index number 1 to PoE interfaces GigabitEthernet 1/2 through
GigabitEthernet 1/8.
<Sysname> system-view
[Sysname] apply poe-profile index 1 interface gigabitethernet 1/2 to gigabitethernet 1/8
Related commands
• display poe-profile interface
• apply poe-profile
display poe device
Use display poe device to display brief PSE information, including the ID, slot number, and state of PSEs.
Syntax
display poe device [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level