R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

232
Field Description
Port Detection Status
Power detection state of a PoE interface:
• disabled—PoE function is disabled.
• searching—PoE interface is searching for the PD.
• on—PoE interface is supplying power for the PD.
• other-fault—There is a fault other than defined in
802.3af.
Port Power Mode
Power mode of a PoE interface:
signal—Power is supplied over signal wires (data pairs).
Port Current Power
Current power of a PoE interface, including PD
consumption power and transmission loss.
The transmission loss usually does not exceed one watt.
Port Average Power Average power of a PoE interface.
Port Peak Power Peak power of a PoE interface.
Port Max Power Maximum power of a PoE interface.
Port Current Current of a PoE interface.
Port Voltage Voltage of a PoE interface.
Port PD Description
Description of the PD connected to the PoE interface, which
is used to identify the type and location of the PD.
# Display power supplying information for all PoE interfaces.
<Sysname> display poe interface
Interface Enable Priority CurPower Operating IEEE Detection
(W) Status class Status
GE1/1 enabled low 4.4 on 1 on
GE1/2 enabled critical 0.0 on - disabled
GE1/3 enabled low 0.0 on - disabled
GE1/4 enabled critical 0.0 on - searching
GE1/5 enabled low 4.0 on 2 on
GE1/6 enabled low 0.0 on - disabled
GE1/7 disabled low 0.0 off - other-fault
--- 2 port(s) on, 8.4(W) consumed, 171.6(W) Remaining ---
Table 50 Command output
Field Description
Interface Shortened form of a PoE interface.
Enable
PoE state:
• enabled.
• disabled.