R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

238
Syntax
display poe pse pse-id interface [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
pse pse-id: Specifies a PSE ID. To view PSE ID and slot mappings, use the display poe device command.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display the state of all PoE interfaces connected to PSE 1.
<Sysname> display poe pse 1 interface
Interface Enable Priority CurPower Operating IEEE Detection
(W) Status class Status
GE1/1 enabled low 4.4 on 1 delivering-power
GE1/2 enabled critical 0.0 power-lack - disabled
GE1/3 enabled low 0.0 power-deny - disabled
GE1/4 enabled critical 0.0 on - searching
GE1/5 enabled low 4.0 power-limit 2 delivering-power
GE1/6 enabled low 0.0 power-itself - disabled
GE1/7 disabled low 0.0 off - fault
--- 2 port(s) on, 8.4(W) consumed, 171.6(W) Remaining ---
Table 54 Command output
Field Description
Interface Shortened form of a PoE interface.
Enable
PoE enabled/disabled state. For the value, see Table
49.
Priority Priority of a PoE interface. For the value, see Table 49.
CurPower Current power of a PoE interface.
Operating
Operating state of a PoE interface. For the value,
see Table 49.
IEEE PD power class.
Detection
Power detection state of a PoE interface. For the value,
see Table 49.