R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

283
After the above configuration, log in to the FTP server by using the username ftp. The following log
information is displayed on the log host (the -DevIP=2.2.2.2 field identifies the source IP address):
<189>May 31 05:38:14 2003 Sysname %%10FTPD/5/FTPD_LOGIN(l): -DevIP=2.2.2.2; User ftp
(192.168.1.23) has logged in successfully.
info-center monitor channel
Use info-center monitor channel to configure the monitor channel. The system uses this channel to output
information to the monitor.
Use undo info-center monitor channel to restore the default monitor output channel.
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
Default
The system outputs information to the monitor through channel 1.
Views
System view
Default command level
2: System level
Parameters
channel-number: Specifies a channel by its number in the range of 0 to 9.
channel-name: Specifies a channel by its name, a default name or a self-defined name. For information
about how to a channel name, see info-center channel name.
Usage guidelines
The info-center monitor channel command takes effect only after the information center enabled with the
info-center enable command.
Examples
# Output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
info-center security-logfile alarm-threshold
Use info-center security-logfile alarm-threshold to set the alarm threshold for security log file usage.
Use undo info-center security-logfile alarm-threshold to restore the default.
Syntax
info-center security-logfile alarm-threshold usage
undo info-center security-logfile alarm-threshold
Default
The alarm threshold for security log file usage is 80. That is, when the usage of the security log file
reaches 80%, the system outputs a message to inform the administrator.