R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

320
[Sysname-ns6-aggregation-as] enable
Related commands
ipv6 netstream aggregation
ipv6 netstream
Use ipv6 netstream to enable IPv6 NetStream on a specific interface.
Use undo ipv6 netstream to disable IPv6 NetStream on the specified interface.
Syntax
ipv6 netstream { inbound | outbound }
undo ipv6 netstream { inbound | outbound }
Default
IPv6 NetStream is disabled on both the device and an interface.
Views
Interface view
Default command level
3: Manage level
Parameters
inbound: Filters incoming IPv6 traffic.
outbound: Filters outgoing IPv6 traffic.
Examples
# Enable IPv6 NetStream for incoming traffic on interface Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ipv6 netstream inbound
ipv6 netstream aggregation
Use ipv6 netstream aggregation to set an IPv6 NetStream aggregation mode, and enter the IPv6
NetStream aggregation view.
Syntax
ipv6 netstream aggregation { as | bgp-nexthop | destination-prefix | prefix | protocol-port |
source-prefix }
Views
System view
Default command level
3: Manage level
Parameters
as: Specifies the AS aggregation by source AS number, destination AS number, inbound interface index,
and outbound interface index.