R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

321
bgp-nexthop: Specifies the BGP nexthop aggregation by BGP next hop IPv6 address, and outbound
interface index.
destination-prefix: Specifies the destination-prefix aggregation by destination AS number, destination
address mask length, destination prefix, and outbound interface index.
prefix: Specifies the source and destination prefix aggregation by source AS number, destination AS
number, source address mask length, destination address mask length, source prefix, destination prefix,
inbound interface index, and outbound interface index.
protocol-port: Specifies the protocol-port aggregation by protocol number, source port, and destination
port.
source-prefix: Specifies the source-prefix aggregation by source AS number, source address mask length,
source prefix, and inbound interface index.
Usage guidelines
In IPv6 NetStream aggregation view, you can perform the following tasks:
• Enable or disable the specific IPv6 NetStream aggregation.
• Configure the source interface, destination IP address, and destination port for IPv6 NetStream
data export.
Examples
# Set the IPv6 NetStream aggregation mode as AS, and enter the NetStream AS aggregation view.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns6-aggregation-as]
Related commands
• enable
• ipv6 netstream export host
• ipv6 netstream export source
ipv6 netstream export rate
Use ipv6 netstream export rate to configure the limit on the IPv6 NetStream data export.
Use undo ipv6 netstream export rate to remove the IPv6 NetStream data export limit.
Syntax
ipv6 netstream export rate rate
undo ipv6 netstream export rate
Default
The export rate of IPv6 NetStream data is not limited.
Views
System view
Default command level
3: Manage level
Parameters