R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

322
rate: Specifies the maximum rate for exporting IPv6 NetStream data, in the unit of the maximum number
of packets per second, in the range of 1 to 1000.
Examples
# Allow 10 packets at most to be exported per second.
<Sysname> system-view
[Sysname] ipv6 netstream export rate 10
ipv6 netstream export host
Use ipv6 netstream export host to set the destination address and destination UDP port number for IPv6
NetStream data export.
Use undo ipv6 netstream export host to delete the specified export address or all export addresses that
are configured in this view.
Syntax
ipv6 netstream export host ip-address udp-port [ vpn-instance vpn-instance-name ]
undo ipv6 netstream export host [ ip-address [ vpn-instance vpn-instance-name ] ]
Default
No destination address or destination UDP port number is configured in system view or aggregation
view.
Views
System view, NetStream aggregation view
Default command level
3: Manage level
Parameters
ip-address: Specifies the destination IP address for IPv6 NetStream data export. Only IPv4 addresses are
supported.
udp-port: Specifies the destination UDP port number for IPv6 NetStream data export, in the range of 0
to 65535.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN that the IPv6 NetStream data export
destination belongs to. The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters.
If the destination is on the public network, do not specify the option.
Usage guidelines
If an aggregation view is not enabled, you cannot use the display ipv6 netstream export command to
view information (including the destination address and destination UDP port number) of the
aggregation view.
If the ip-address argument is not specified in the undo ipv6 netstream export host command, all the IP
addresses configured in the current view are removed.
You can configure the same destination address and destination UDP port number in different
aggregation views.
The destination address and destination UDP port number configured in aggregation view takes
precedence over those configured in system view. If no destination address or destination UDP port
number is configured in aggregate view, those configured in system view apply.