R2511-HP MSR Router Series Network Management and Monitoring Command Reference(V5)

323
Up to four different destination addresses, including addresses in different VPNs, can be configured in
one aggregation view. If you have configured the destination addresses with the same IP addresses but
different UDP port numbers, the last configuration takes effect. If you configure different VPN names,
configure destination addresses with the same IP address and UDP port number.
IPv6 NetStream traditional data is exported to all destination addresses configured in system view, and
IPv6 NetStream aggregation data is exported to all destination addresses configured in the related
aggregation view. If you expect IPv6 NetStream aggregation data only, configure the destination
address in the aggregation view, and do not configure the destination address in system view. Otherwise,
the IPv6 NetStream traditional data is also exported, which will increase the bandwidth occupation.
Examples
# Configure the address for IPv6 NetStream data export as 1.1.1.1, UDP port 5000, and vpn1.
<Sysname> system-view
[Sysname] ipv6 netstream export host 1.1.1.1 5000 vpn-instance vpn1
Related commands
• ipv6 netstream aggregation
• ipv6 netstream export source
ipv6 netstream export source
Use ipv6 netstream export source to configure the source interface for IPv6 NetStream data export.
Use undo ipv6 netstream export source to remove the configuration.
Syntax
ipv6 netstream export source interface interface-type interface-number
undo ipv6 netstream export source
Default
The interface connecting to the NetStream server, where the IPv6 NetStream data is sent out, is used as
the source interface.
Views
System view, NetStream aggregation view
Default command level
3: Manage level
Parameters
interface-type interface-number: Specifies a source interface by its type and number for NetStream data
export.
Usage guidelines
Different source interfaces can be configured in different aggregation views.
If no source interface is configured in NetStream aggregation view, the source interface configured in
system view is used.
HP recommends that you connect the network management interface to the NSC and configure it as the
source interface.
Examples