R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

3
Ste
p
Command Remarks
2. Enable the SNMP agent.
snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can also enable the SNMP
agent by using any command that
begins with snmp-agent except for
the snmp-agent
calculate-password command.
3. Configure system information
for the SNMP agent.
snmp-agent sys-info { contact
sys-contact | location sys-location
| version { all | { v1 | v2c |
v3 }* } }
Optional.
The defaults are as follows:
• Contact—null.
• Location—null.
• Version—SNMPv3.
4. Configure the local engine ID.
snmp-agent local-engineid
engineid
Optional.
The default local engine ID is the
company ID plus the device ID.
After you change the local engine
ID, the existing SNMPv3 users
become invalid, and you must
re-create the SNMPv3 users.
5. Create or update a MIB view.
snmp-agent mib-view { excluded |
included } view-name oid-tree
[ mask mask-value ]
Optional.
By default, the MIB view
ViewDefault is predefined and its
OID is 1.
Each view-name oid-tree pair
represents a view record. If you
specify the same record with
different MIB subtree masks
multiple times, the most recent
configuration takes effect. Except
for the four subtrees in the default
MIB view, you can create up to 16
unique MIB view records.
6. Configure an SNMPv3 group.
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ] [ acl
acl-number | acl ipv6
ipv6-acl-number ] *
By default, no SNMP group exists.
7. Convert a plaintext key to a
ciphertext (encrypted) key.
snmp-agent calculate-password
plain-password mode { 3desmd5 |
3dessha | md5 | sha }
{ local-engineid |
specified-engineid engineid }
Optional.