R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

116
Ste
p
Command Remarks
5. Configure the source IP
address of probe packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no probe packets can
be sent out.
Configuring optional parameters for an NQA operation
Unless otherwise specified, the following optional parameters apply to all NQA operation types.
To configure optional parameters for an NQA operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is
created.
3. Enter a specified NQA
operation type view.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
N/A
4. Configure a description.
description text
Optional.
By default, no description is
configured.
5. Specify the interval at which
the NQA operation repeats.
frequency interval
Optional.
By default, the interval between
two consecutive voice tests is
60000 milliseconds. For other
tests, the interval is 0 milliseconds.
Only one operation is performed.
If the operation is not completed
when the interval expires, the next
operation does not start.
6. Specify the probe times.
probe count times
Optional.
By default, an NQA operation
performs one probe.
The voice operation can perform
only one probe, and does not
support this command.
7. Specify the probe timeout
time.
probe timeout timeout
Optional.
By default, the timeout time is 3000
milliseconds.
This setting is not available for the
UDP jitter or voice operation.