R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

161
Ste
p
Command
2. Apply the PoE profile to one or multiple PoE
interfaces.
apply poe-profile { index index | name profile-name }
interface interface-range
To apply the PoE profile in interface view:
Ste
p
Command
1. Enter system view.
system-view
2. Enter PoE interface view.
interface interface-type interface-number
3. Apply the PoE profile to the current PoE interface.
apply poe-profile { index index | name profile-name }
Upgrading PSE processing software in service
You can upgrade the PSE processing software in service in either of the following two modes:
• Refresh mode—This mode enables you to update the PSE processing software without deleting it.
You can upgrade the PSE processing software in the refresh mode at the CLI.
• Full mode—This mode deletes the PSE processing software and reloads it. If the PSE processing
software is damaged (so you cannot execute any PoE commands), you can upgrade the PSE
processing software in full mode to restore the PSE function.
An in-service PSE processing software upgrade might be unexpectedly interrupted (for example, if an
error causes the device to reboot). If you cannot upgrade the PSE processing software in full mode after
a reboot, you can power off the device and restart it before you upgrade it in full mode again. After the
upgrade, restart the device manually to make the new PSE processing software take effect.
To upgrade the PSE processing software in service:
Ste
p
Command
1. Enter system view.
system-view
2. Upgrade the PSE processing software in service.
poe update { full | refresh } filename pse pse-id
Displaying and maintaining PoE
Task Command Remarks
Display PSE information.
display poe device [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display the power supply state
of the specified PoE interface.
display poe interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display power information for
PoE interfaces.
display poe interface power [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.