R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

163
Figure 55 Network diagram
Configuration procedure
# Enable PoE for the PSE.
<Sysname> system-view
[Sysname] poe enable pse 10
[Sysname] poe enable pse 16
# Set the maximum power of PSE 10 to 400 watts.
[Sysname] poe max-power 400 pse 10
# Enable PoE on GigabitEthernet 3/1 and GigabitEthernet 5/1.
[Sysname] interface gigabitethernet 3/1
[Sysname-GigabitEthernet3/1] poe enable
[Sysname-GigabitEthernet3/1] quit
[Sysname] interface gigabitethernet 5/1
[Sysname-GigabitEthernet5/1] poe enable
[Sysname-GigabitEthernet5/1] quit
# Enable PoE on GigabitEthernet 3/2, and set its power priority to critical.
[Sysname] interface gigabitethernet 3/2
[Sysname-GigabitEthernet3/2] poe enable
[Sysname-GigabitEthernet3/2] poe priority critical
[Sysname-GigabitEthernet3/2] quit
# Enable PoE on GigabitEthernet 5/2, and set its maximum power to 9000 milliwatts.
[Sysname] interface gigabitethernet 5/2
[Sysname-GigabitEthernet5/2] poe enable
[Sysname-GigabitEthernet5/2] poe max-power 9000
Verifying the configuration
After the configuration takes effect, the IP telephones and AP devices are powered and can operate
correctly.