R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

184
Ste
p
Command Remarks
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
By default, the timestamp format
for log, trap and debug
information is date.
7. Return to user view.
quit N/A
8. Enable system information
output to the monitor terminal.
terminal monitor
The default setting is disabled.
You must first execute this
command, and then you can
enable the display of debugging,
log, and trap information on the
monitor terminal.
9. Enable the display of system
information on the monitor
terminal.
• Enable the display of debug
information on the monitor
terminal:
terminal debugging
• Enable the display of log
information on the monitor
terminal:
terminal logging
• Enable the display of trap
information on the monitor
terminal:
terminal trapping
Optional.
By default, the monitor terminal
displays log and trap information,
and discards debug information.
For more information about terminal access, see Terminal Access Configuration Guide.
Outputting system information to a log host
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable the information
center.
info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel
number.
info-center channel channel-number
name channel-name
Optional.
See Table 6 for
default channel names.
4. Configure an output rule
for the log host.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap { level
severity | state state } * ] *
Optional.
See "Default output rules of system
informa
tion."
5. Specify the source IP
address for the log
information.
info-center loghost source
interface-type interface-number
Optional.
By default, the source IP address of log
information is the primary IP address of
the matching route's egress interface .