R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

193
Task Command Remarks
(Optional) Upload the security log
file to the FTP server.
• Establish an FTP connection:
ftp [ server-address
[ service-port ]
[ [ vpn-instance
vpn-instance-name ] |
[ source { interface
interface-type
interface-number | ip
source-ip-address } ] ] ]
• Establish an FTP connection in
an IPv6 network:
ftp ipv6 [ server-address
[ service-port ] [ source ipv6
source-ipv6-address ] [ -i
interface-type
interface-number ] ]
• Upload a file on the client to
the remote FTP server:
put localfile [ remotefile ]
• Download a file from a
remote FTP server and save it:
get remotefile [ localfile ]
Optional.
The ftp and ftp ipv6 commands are
available in user view. The other
commands are available in FTP
client view.
For more information about these
commands, see Fundamentals
Command Reference.
For all other operations supported
by the device acting as an FTP
client, see Fundamentals
Configuration Guide.
Enabling synchronous information output
System log output interrupts ongoing configuration operations, obscuring previously entered commands.
Synchronous information output shows the obscured commands. It also provides a command prompt in
command editing mode, or a [Y/N] string in interaction mode so you can continue your operation from
where you were stopped.
If system information, such as log information, is output before you input any information under the
current command line prompt, the system does not display the command line prompt after the system
information output.
If system information is output when you are inputting some interactive information (non-Y/N
confirmation information), the system displays your previous input in a new line but does not display the
command line prompt.
To enable synchronous information output:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable synchronous
information output.
info-center synchronous Disabled by default.