R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)
67
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter cluster view.
cluster N/A
3. Add a device to the blacklist.
black-list add-mac mac-address Optional.
4. Remove a device from the
blacklist.
black-list delete-mac { all |
mac-address }
Optional.
5. Confirm the current topology and
save it as the standard topology.
topology accept { all [ save-to
{ ftp-server | local-flash } ] |
mac-address mac-address |
member-id member-number }
Optional.
6. Save the standard topology to
the FTP server or the local Flash.
topology save-to { ftp-server |
local-flash }
Optional.
7. Restore the standard topology.
topology restore-from { ftp-server |
local-flash }
Optional.
Configuring interaction for a cluster
You configure the FTP/TFTP server, NMS and log host settings for the cluster on the cluster management
device.
• All cluster members access the FTP/TFTP server through the management device.
• All cluster members output their log data to the management device, which converts the IP address
for the log data packets before forwarding the packets to the log host.
• All cluster members send their traps to the SNMP NMS through the management device.
To isolate cluster management and control packets from the external networks for security, HP
recommends you configure the ports connected to the external networks as not allowing the
management VLAN to pass through. If the port connected to the NMS, FTP/TFTP server, or log host is
one of these ports, you must specify a VLAN interface other than the management VLAN interface as the
network management interface for communicating with these devices. Otherwise, communication failure
will occur.
To configure the interaction for the cluster:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter cluster view.
cluster
N/A
3. Configure the FTP server
shared by the cluster.
ftp-server ip-address [ user-name
username password { cipher |
simple } password ]
By default, no FTP server is
configured for a cluster.
4. Configure the TFTP server
shared by the cluster.
tftp-server ip-address
By default, no TFTP server is
configured for a cluster.
5. Configure the log host shared
by the member devices in the
cluster.
logging-host ip-address
By default, no log host is
configured for a cluster.