R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

68
Ste
p
Command Remarks
6. Configure the SNMP NM host
shared by the cluster.
snmp-host ip-address
[ community-string read string1
write string2 ]
By default, no SNMP host is
configured.
7. Configure the NM interface of
the management device.
nm-interface vlan-interface
interface-name
Optional.
Configuring the SNMP configuration synchronization function
SNMP configuration synchronization simplifies SNMP configuration in a cluster by enabling the
management device to propagate its SNMP settings to all member devices on a whitelist. These SNMP
settings are retained on the member devices after they are removed from the whitelist or the cluster is
dismissed. For more information about SNMP, see "Configuring SNMP."
To configure the SNMP configuration synchronization function:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter cluster view.
cluster N/A
3. Configure the SNMP
community name shared by a
cluster.
cluster-snmp-agent community
{ read | write } community-name
[ mib-view view-name ]
N/A
4. Configure the SNMPv3 group
shared by a cluster.
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ]
N/A
5. Create or update information
about the MIB view shared by
a cluster.
cluster-snmp-agent mib-view
included view-name oid-tree
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
6. Add a user for the SNMPv3
group shared by a cluster.
cluster-snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 |
sha } [ cipher | simple ]
auth-password ] [ privacy-mode
des56 [cipher | simple ]
priv-password ]
N/A
Configuring Web user accounts in batches
Configuring Web user accounts in batches enables you to do the following:
• Through the Web interface, configure, on the management device, the username and password
used to log in to the cluster devices (including the management device and member devices).
• Synchronize the configurations to the member devices on the whitelist.
This operation is equal to performing the configurations on the member devices. You need to enter your
username and password when you log in to the devices (including the management device and member