R2511-HP MSR Router Series Network Management and Monitoring Configuration Guide(V5)

82
To configure the close-wait timer for the CPE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Set the CPE close-wait timer.
cwmp cpe wait timeout seconds
Optional.
The default setting is 30 seconds.
Configuring the CPE working mode
Configure the device to operate in one of the following CPE modes depending on its position in the
network:
• Gateway mode—Enables the ACS to manage the device and any CPE attached to the device. Use
this mode if the device is the egress to the WAN and has lower-level CPEs.
• Device mode—If no CPEs are attached to the device, configure the device to operate in device
mode.
Disable CWMP before you change the CPE working mode.
To configure the working mode of the CPE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Configure the working mode
of the CPE.
cwmp device-type { device |
gateway }
By default, the device operates in
gateway mode.
Specifying an SSL client policy for HTTPS connection to ACS
CWMP uses HTTP or HTTPS for data transmission. If the ACS uses HTTPS for secure access, its URL
begins with https://. You must configure an SSL client policy for the CPE to authenticate the ACS for
establishing an HTTPS connection. For more information about configuring SSL client policies, see
Security Configuration Guide.
To specify an SSL client policy for the CPE to establish an HTTPS connection to the ACS:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CWMP view.
cwmp N/A
3. Specify an SSL client policy.
ssl client-policy policy-name
By default, no SSL client policy is
configured.