R2511-HP MSR Router Series Security Command Reference(V5)

293
ip-pool
Use ip-pool to specify an IPv4 address pool for an IKEv2 profile.
Use undo ip-pool to remove the configuration.
Syntax
ip-pool pool-name
undo ip-pool
Default
An IKEv2 profile references no address pool.
Views
IKEv2 profile view
Default command level
2: System level
Parameters
pool-name: Specifies the IPv4 address pool name, a case-insensitive string of 1 to 32 characters.
Usage guidelines
If the peer sends IPv4 address allocation requests and the local end accepts address allocation requests,
the local end assigns an available IPv4 addresses in the profile's IPv4 address pool to the peer and sends
the address to the peer in an IKE response packet.
Examples
# Configure IKEv2 profile profile1 to use IPv4 address pool ipv4pool.
<Sysname> system-view
[Sysname] ikev2 profile profile1
[Sysname-ikev2-profile-profile1] ipv4-pool ipv4pool
Related commands
• ikev2 ip-pool
• ip-mask
ipv6-mask
Use ipv6-mask to specify a prefix length for the local IPv6 address pool.
Use undo ipv6-mask to restore the default.
Syntax
ipv6-mask prefix-length
undo ipv6-mask
Default
The prefix length of a local IPv6 address pool referenced by an IKEv2 profile is 128.
Views
IKEv2 profile view