R2511-HP MSR Router Series Security Command Reference(V5)

366
Field Descri
p
tion
Work-mode
User's working mode:
• Primary.
• Secondary.
• Stand-alone.
The MSR routers do not support this field, and the field is always
"Stand-alone."
VPN instance MPLS L3VPN to which the portal server belongs.
MAC MAC address of the portal user.
IP IP address of the portal user.
Vlan VLAN to which the portal user belongs.
Interface Interface to which the portal user is attached.
Total 1 user(s) matched, 1 listed Total number of portal users.
portal auth-network
Use portal auth-network to configure a portal authentication source subnet on an interface. You can use
this command to configure multiple portal authentication source subnets on an interface. Then, only HTTP
packets from the subnets can trigger portal authentication on the interface. If an unauthenticated user is
not on any authentication source subnet, the access device discards all the user's HTTP packets that do
not match any portal-free rule.
Use undo portal auth-network to remove a specific portal authentication source subnet or all portal
authentication subnets.
Syntax
portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
Default
The portal authentication source IP subnet is 0.0.0.0/0, which means users in all subnets must pass
portal authentication.
Views
Interface view
Default command level
2: System level
Parameters
network-address: IP address of the authentication source subnet.
mask-length: Length of the subnet mask, in the range of 0 to 32.
mask: Subnet mask, in dotted decimal notation.
all: Specifies all authentication source subnets.