R2511-HP MSR Router Series Security Command Reference(V5)

546
Parameters
vlan-id: Specifies the ID of the VLAN in which HABP packets are to be transmitted. The value range is 1
to 4094.
Usage guidelines
In a cluster, if a member device with 802.1X authentication or MAC authentication enabled is attached
to some other member devices of the cluster, you must also configure HABP server on this device.
Otherwise, the cluster management device will not be able to manage the devices attached to this
member device. For information about the cluster function, see Network Management and Monitoring
Configuration Guide.
Examples
# Configure HABP to operate in server mode and specify the VLAN for HABP packets as VLAN 2.
<Sysname> system-view
[Sysname] habp server vlan 2
habp timer
Use habp timer to set the interval at which the device sends HABP request packets.
Use undo habp timer to restore the default.
Syntax
habp timer interval
undo habp timer
Default
The default interval is 20 seconds.
Views
System view
Default command level
2: System level
Parameters
interval: Specifies the interval (in seconds) at which the device sends HABP request packets. The value
range is 5 to 600.
Usage guidelines
This command is required only on the HABP server.
Examples
# Set the interval at which the device sends HABP request packets to 50 seconds.
<Sysname> system-view
[Sysname] habp timer 50