R2511-HP MSR Router Series Security Configuration Guide(V5)

455
Ste
p
Command Remarks
3. Configure HABP to operate in
client mode.
undo habp server
Optional.
HABP operates in client mode by
default.
The VLAN to which an HABP client
belongs must be the same as that
specified on the HABP server for
transmitting HABP packets.
4. Specify the VLAN to which the
HABP client belongs.
habp client vlan vlan-id
Optional.
By default, an HABP client belongs
to VLAN 1.
Displaying and maintaining HABP
Task Command Remarks
Display HABP configuration
information.
display habp [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Display HABP MAC address table
entries.
display habp table [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
Display HABP packet statistics.
display habp traffic [ | { begin |
exclude | include }
regular-expression ]
Available in any view.
HABP configuration example
Network requirements
As shown in Figure 143, the device is attached with access devices Switch A and Switch B. 802.1X
authentication is configured on the device for central authentication and management of users (Host A
through Host D).
For communication between Switch A and Switch B, enable HABP server on the device, enable HABP
client on Switch A and Switch B, and specify VLAN 1 for HABP packets.
Configure the HABP server to send HABP request packets to the HABP clients in VLAN 1 at an interval
of 50 seconds.