R2511-HP MSR Router Series Terminal Access Command Reference(V5)

20
Views
Terminal template view
Default command level
2: System level
Parameters
ascii-code&<1-3>: Sets the ASCII value of the terminal reset hotkey, in the range of 1 to 255. The &<1-3>
means that you can provide up to three ASCII values.
Usage guidelines
When you press the terminal reset hotkey after a terminal fault occurs, the router tears down and then
re-establishes the TCP connection with the FEP.
The ASCII value of the redrawing hotkey configured must be different from that of any other hotkey
configured on the device. Otherwise, hotkey conflicts will occur. For example, the hotkey value cannot be
17 or 19 because these values are used for flow control. In addition, using the hotkey may not get a fast
response when the terminal display is busy.
Examples
# Configure the terminal reset hotkey as <Ctrl+A> by setting its ASCII value to 1.
<Sysname> system-view
[Sysname] rta template abc
[Sysname-rta-template-abc] resetkey 1
rta bind
Use rta bind to configure a character string for router authentication.
Use undo rta bind to restore the default.
Syntax
rta bind { mac-address interface interface-type interface-number | string string }
undo rta bind
Default
No authentication string is configured on the router.
Views
System view
Default command level
2: System level
Parameters
mac-address interface interface-type interface-number: Uses the specified interface's MAC address as
the character string for router authentication.
string string: Uses a user-defined string for router authentication. string is a user-defined string of 1 to 30
characters.
Usage guidelines
This configuration is used to authenticate the connection between the router and the FEP. If the
authentication succeeds (that is, if the MAC address sent by the router and that configured on the FEP are