R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

95
Ste
p
Command
1. Enter system view.
system-view
2. Manually disconnect terminals from
receivers.
ipta disconnect { all | service service-name | terminal ttyid
[ service service-name ] }
Enabling encryption
This feature is only supported by TTY terminal access. ETelnet terminal access and SSH terminal access
use the ETelnet protocol and SSH protocol respectively to implement encryption, and no commands are
needed.To enable data encryption:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPTA service view.
ipta service service-name N/A
3. Enable data encryption using the
specified encryption algorithm.
encryption algorithm { aes | quick } Disabled by default.
Configuring source address binding
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPTA service view.
ipta service service-name N/A
3. Configure source
address binding.
source ip ip-address
By default, no source IP address is bound to
the service. The IP address of the outbound
interface is used as the source IP address of
TCP connections.
Configure VPN binding
You can configure VPN binding in system view or terminal view.
To configure VPN binding in system view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Bind terminals to the VPN.
ipta bind vpn-instance vpn-name
terminal ttyid-list
No terminal-VPN binding is
configured by default.
To configure VPN binding in terminal view:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter terminal view.
ipta terminal ttyid N/A