R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

97
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPTA service view.
ipta service service-name N/A
3. Configure the IP terminal
authentication mode as
scheme.
authentication-mode scheme
By default, the IP terminal
authentication mode is none. In
other words, no terminal
authentication is performed.
4. Return to system view.
quit N/A
5. Create a local user and enter
local user view.
local-user user-name
By default, no local user is
configured on the device.
For more information, see
Security Command Reference.
6. Configure an authentication
password.
password { cipher | simple }
password
For more information, see
Security Command Reference.
7. Configure the service type for
terminal access.
service-type telnet
The service type for IP terminal
access must be Telnet and
user-level based authorization is
not supported.
For more information, see
Security Command Reference.
NOTE:
• If you are using remote AAA authentication, you must configure corresponding authentication schemes
on access devices. For more information about the configuration, see
Security Configuration Guide .
Configuring the processing approach for special characters
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter terminal view.
ipta terminal ttyid N/A
3. Specify a processing
approach for CR and CRLF.
transform enter { cr | crlf }
By default, the system does not
transform CR and CRLF.
Configuring link detection
The router periodically sends keepalives to check the state of TCP connections to a terminal and to an FEP.
Keepalive parameters only affect connections established after they were configured.
To configure link detection:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A