R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

99
This command only filters control characters 0x11 and 0x13 carried in data flows sent from terminals to
the FEP.
• 0x13—Enables flow control.
• 0x11—Disables flow control.
To enable filtering of flow control characters:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter terminal view.
ipta terminal ttyid N/A
3. Enable filtering of flow control
characters.
filter flow-control character Disabled by default.
Enabling screen saving
This command will not affect terminal connections that have already been established.
To enable screen saving:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPTA service view.
ipta service service-name N/A
3. Enable screen saving.
screen-save enable Enabled by default.
4. Set the screen height and
width.
screen-size height height width
width
Optional.
24 characters for height and 80
characters for width by default.
Setting the terminal screen display size
You cannot modify the screen display size for IP terminals that have established connections.
To set the terminal screen display size:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPTA service view.
ipta service service-name N/A
3. Set the terminal screen display
size.
screen-size height
height-in-characters width
width-in-characters
By default, the screen can display up
to 24 lines and 80 columns of
characters.
Configuring the terminal type
This command will not affect terminal connections that have been established.
Make sure that the terminal type configured is the actual type of the terminal. Otherwise, the screen may
become illegible after the terminal is unlocked.