R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

21
• Configure the receive buffer size before applying the terminal template. If you configure the receive
buffer size after a terminal template is applied, you must remove the application of the terminal
template and apply the terminal template again for the receive buffer size to take effect.
• The ASCII value of the hotkey must be different from the ASCII value of any other hotkey configured
on the device. Otherwise, hotkey conflicts occur. For example, the hotkey value cannot be 17 or 19
because these two values are used for flow control. In addition, using the hotkey may not get a fast
response when the terminal display is busy.
• Make sure that the terminal type configured is the actual type of the terminal. Otherwise, the screen
becomes illegible when it is redrawn or the VTY is changed.
• If you modify the screen saving configuration after a terminal connection is established, use the
update changed-config command to apply the latest configuration.
To configure advanced Telnet initiator settings:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the global
source IP address of TCP
connections.
rta source-ip ip-address
Optional.
Not configured by default.
3. Enable pressing any key
to return.
rta vty-style smart
Optional.
Disabled by default.
4. Enter terminal template
view.
rta template template-name N/A
5. Configure the automatic
link teardown time.
auto-close time
Optional.
0 seconds by default. That is, no
automatic link teardown is performed.
6. Configure the automatic
link establishment time.
auto-link time
Optional.
0 seconds by default. That is, no
automatic link establishment is
performed.
7. Bind a VPN instance.
bind vpn-instance vpn-name
Optional.
Not configured by default.
8. Enable terminal data
read blocking.
data read block
Optional.
Disabled by default.
9. Configure the terminal
data send delay.
data send delay milliseconds
Optional.
0 milliseconds by default. That is, there
is no send delay.
10. Configure the router to
not clear the terminal
receive buffer after a
TCP connection is
established.
driverbuf save
Optional.
By default, the router clears the terminal
receive buffer after a TCP connection is
established.
11. Configure the terminal
buffer size.
driverbuf size number
Optional.
8192 bytes by default.
12. Enable filtering of flow
control characters.
filter flow-control character
Optional.
Disabled by default.