R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

28
Ste
p
Command Remarks
19. Configure the print
language.
print language { chinese |
english }
Optional.
Chinese by default.
20. Set the terminal reset
hotkey.
resetkey ascii-code&<1-3>
Optional.
Not configured by default.
21. Configure the maximum
size of data to be sent at
one time.
sendbuf bufsize size
Optional.
500 bytes by default.
22. Configure the terminal
send buffer threshold.
sendbuf threshold value
Optional.
Not configured by default.
23. Set the terminal
connectivity test hotkey.
testkey ascii-code&<1-3>
Optional.
Not configured by default.
24. Configure TCP parameters.
tcp { recvbuf-size recvsize |
sendbuf-size sendsize |
nodelay | keepalive time count }
Optional.
By default, the receive buffer size is
2048 bytes, send buffer size is 2048
bytes, delay is enabled, keepalive
interval is 50 seconds, and keepalive
number is 3.
25. Configure a description for
a VTY.
vty vty-number description string
Optional.
Not configured by default.
26. Configure a screen code
for a VTY.
vty vty-number screencode string
Optional.
Not configured by default.
27. Configure the VTY
switching hotkey.
vty vty-number hotkey
ascii-code&<1-3>
Optional.
Not configured by default.
28. Enable screen saving.
screen save enable
Optional.
Enabled by default.
29. Set the terminal screen
display size.
screen-size height
height-in-characters width
width-in-characters
By default, the screen can display up to
24 lines and 80 columns of characters.
30. Configure the terminal
type.
terminal type { vt100 | vt220 }
Optional.
vt100 by default.
31. Update the configuration.
update changed-config
Optional.
If you modify the terminal template that
has been applied to an interface, use
this command to apply the latest
configuration. Executing this command
will disconnect connections. Make sure
critical services are not affected.
Configuring the ETelnet receiver
The receiver of ETelnet terminal access is an FEP. An FEP only needs to run the ETelnet server program
(ccbtelnetd) and the corresponding application program. There is no need to modify or compile the Unix
kernel.