R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

Ste

Command

Remarks

30. Configure the terminal type.

terminal type { vt100 | vt220 }

Optional.

vt100 by default.

31. Update the configuration.

update changed-config

Optional.

If you modify the terminal template

that has been applied to an interface,

use this command to apply the latest

configuration. Executing this

command will disconnect

connections. Make sure critical

services are not affected.

Configuring the SSH receiver

The receiver of SSH terminal access is an FEP. An FEP only needs to run the sshd program and the

corresponding application program. There is no need to modify or compile the Unix kernel.

SSH terminal access configuration example

Network requirements

As shown in Figure 7, two Unix FEPs use IP addresses 10.110.96.53 and 10.110.96.54 and use the port

number 22. A terminal is used at the outlet. On the terminal, the first VTY corresponds to FEP 1, with the

VTY switching hotkey of < Alt+A >. The second VTY corresponds to FEP 2, with the VTY switching hotkey

Alt+B and the menu hotkey Alt+C.

Figure 7 Network diagram

Configuration procedure

1. Configure the initiator:

# Enable terminal access.

<Sysname> system-view

[Sysname] rta server enable

# Create a terminal template and enter terminal template view.

[Sysname] rta template temp2

# Configure the menu hotkey as Alt+C

[Sysname-rta-template-temp2] menu hotkey 1 98 13

WAN

FEP 1

FEP 2

Terminal

10.111.0.1/24

Async1/0

10.110.96.54/24

10.110.96.53/24

Initiator

Receiver