R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

36
Basic RTC initiator configuration
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable terminal access on the
router.
rta server enable Disabled by default.
3. Create a terminal template
and enter terminal template
view.
rta template template-name N/A
4. Create a TCP RTC client VTY.
vty vty-number rtc-client remote
ip-address port-number [ source
source-ip ]
After this configuration, the
template cannot be configured
with any TTY, Telnet, or RTC server
VTYs.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
The interface type must be
supported by terminal access.
Synchronous and asynchronous
interfaces are supported.
7. Configure the asynchronous
serial interface to operate in
flow mode.
async mode flow
Use either command.
By default, an asynchronous serial
interface operates in the protocol
mode, an AUX interface operates
in the flow mode, and a serial
interface operates in the PPP
protocol mode.
For more information about the
async mode flow command, see
the async mode command in
Interface Command Reference.
8. Configure the protocol type of
the synchronous serial
interface as HDLC.
link-protocol hdlc
9. Apply the template to the
interface.
rta terminal template-name
terminal-number [ backup ]
After you apply the template to the
interface, you must set the flow
control mode of the user interface
corresponding to the interface to
software flow control. To view
associations between interfaces
and user interfaces, use the display
user-interface command.
10. Return to system view.
quit N/A
11. Enter TTY user interface view.
user-interface { first-num1
[ last-num1 ] | tty first-num2
[ last-num2 ] }
For more information about the
user-interface command, see the
user-interface command in
Fundamentals Command
Reference.