R2511-HP MSR Router Series Terminal Access Configuration Guide(V5)

Configuration procedure

1. Configure TCP_11_Clients (Router A and Router C):

# Enable terminal access.

<Sysname> system-view

[Sysname] rta server enable

# Create a terminal template and enter terminal template view.

[Sysname] rta template rtcclient

# Configure the VTY.

[Sysname-rta-template-rtcclient] vty 0 rtc-client remote 1.1.1.3 2000

# Apply the template to the interface.

[Sysname] interface async 1/0

[Sysname-Async1/0] async mode flow

[Sysname-Async1/0] rta terminal rtcclient 1

2. Configure the relay server (Router B):

# Enable terminal access relay.

<Sysname> system-view

[Sysname] rta relay enable

# Configure a listening port.

[Sysname] rta relay listen-port 2000

UDP RTC one-to-one configuration example

Network requirements

As shown in Figure 11, Router A serves as a UDP_11_Client, and Router B serves as a UDP_11_Server. The

two routers are connected to terminal devices through Serial 2/0, respectively.

The server uses UDP port 3000 and the client uses UDP port 3001.

Figure 11 Network diagram

Configuration procedure

1. Configure the UDP_11_Client (Router A):

# Enable terminal access.

<Sysname> system-view

[Sysname] rta server enable

Synchronous

terminal A

Synchronous

terminal B

Serial2/0

1.1.1.1

Router A

Serial2/0

1.1.1.3

Router B