R2511-HP MSR Router Series Voice Command Reference(V5)

91
open-trunk
Use open-trunk to enable E&M non-signaling mode.
Use undo open-trunk to disable the E&M non-signaling mode.
Syntax
open-trunk { caller monitor interval | called }
undo open-trunk
Default
The E&M non-signaling mode is disabled.
Views
E&M voice subscriber line view
Default command level
2: System level
Parameters
caller monitor interval: Enables the local voice gateway to use E&M non-signaling mode when serving
as the calling side and specifies the monitoring interval in the range 60 to 600 seconds.
called: Enables the local voice gateway to use E&M non-signaling mode when serving as the called side.
Examples
# Configure the private line auto ring-down (PLAR) function on voice subscriber line 5/0 so that 100 is
automatically dialed out when the subscriber picks up the phone. Enable E&M non-signaling mode on
the calling voice gateway and specify the monitoring interval as 120 seconds.
<Sysname> system-view
[Sysname] subscriber-line 5/0
[Sysname-subscriber-line5/0] private-line 100
[Sysname-subscriber-line5/0] open-trunk caller monitor 120
plc-mode
Use plc-mode to configure a packet loss compensation mode for the analog FXS/FXO voice subscriber
line.
Use undo plc-mode to restore the default.
Syntax
plc-mode { general | specific }
undo plc-mode
Default
The gateway-specific algorithm is used for packet loss compensation.
Views
Analog FXS voice subscriber line view, analog FXO voice subscriber line view
Default command level
2: System level