R2511-HP MSR Router Series Voice Command Reference(V5)

95
ring-detect frequency
Use ring-detect frequency to set the frequency value for ring detection.
Use undo ring-detect frequency to restore the default.
Syntax
ring-detect frequency value
undo ring-detect frequency
Default
The frequency for ring detection is 40 Hz.
Views
Analog FXO voice subscriber line view
Default command level
2: System level
Parameters
value: Frequency value for ring detection, in Hz. The value is in the range 30 to 100 with the step of 10.
Usage guidelines
The following voice modules support this command:
• SIC-2FXS1FXO
• DSIC-4FXS1FXO
Examples
# Set the frequency value for ring detection on FXO voice subscriber line 1/0 to 100 Hz.
<sysname> system-view
[sysname] subscriber-line 1/0
[sysname-subscriber-line1/0] ring-detect frequency 100
send-busytone
Use send-busytone to enable busy tone sending on the FXO interface.
Use undo send-busytone to disable busy tone sending on the FXO interface.
Syntax
send-busytone { enable | time seconds }
undo send-busytone { enable | time }
Default
Busy tone sending is disabled.
Views
Analog FXO voice subscriber line view
Default command level
2: System level