R2511-HP MSR Router Series Voice Command Reference(V5)

108
Views
Voice view
Default command level
2: System level
Parameters
machine-time value: Sets the answering machine recognition time in milliseconds. The value must be
multiples of 10 in the range of 10 to 60000. If the greeting of the called party lasts longer than the
answering machine recognition time, the called party will be considered as an answering machine.
max-analyze-time value: Sets the maximum time in milliseconds for the AMD function to analyze the
voice of the speaker. The time starts from the off-hook of the called party. The value must be multiples of
10 in the range of 10 to 60000.
min-silence-time value: Sets the minimum silent time in milliseconds after a valid voice. The value must be
multiples of 10 in the range of 10 to 60000.
valid-voice-time value: Sets the minimum time in milliseconds for the AMD function to detect a valid time.
The value must be multiples of 10 in the range of 10 to 60000.
voice-energy-threshold value: Sets the voice energy threshold in the range of 10 to 5000.
Usage guidelines
There are four AMD detection results: voice, automatic, silence and unknown.
Examples
# Set the maximum time for the AMD function to analyze the voice of the speaker to 5 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] amd parameter max-analyze-time 5000
ani
NOTE:
This command applies to R2 signaling only.
Use ani to enable the terminating side to request calling party information (service category and calling
number) from the originating side during call connection.
Use undo ani to disable the terminating side from requesting calling party information from the
originating side.
Syntax
ani { all | ka }
undo ani
Default
The terminating side does not request calling party information from the originating side during call
connection.
Views
R2 CAS view