R2511-HP MSR Router Series Voice Command Reference(V5)

109
Default command level
2: System level
Parameters
all: Specifies the remote end to send the category of the calling party and calling number.
ka: Specifies the remote end to send only the category of the calling services.
Usage guidelines
Configure the local end with this command to support automatic number identification.
In normal situations, configure the all keyword. Use the ka keyword only when required by the connected
switch to prevent call failures.
Examples
# Request the remote office to send calling number category and calling number during call connection.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all
Related commands
• cas
• ani-offset
ani-offset
NOTE:
This command applies to R2 signaling only.
Use ani-offset to set the number of dialed digits to be collected before the requesting of the calling party
information.
Use undo ani-offset to restore the default value.
Syntax
ani-offset number
undo ani-offset
Default
The number of digits to be collected before the requesting of the calling party information is 1.
Views
R2 CAS view
Default command level
2: System level
Parameters
number: Number of digits to be collected in the range of 1 to 10.