R2511-HP MSR Router Series Voice Command Reference(V5)

110
Usage guidelines
When the number of collected digits is smaller than the set value, the system will wait for the next digit
until the timer expires. When the number of collected digits equals to or exceeds the set value, the system
will request the calling party information.
Before you can configure this command, you must configure the ani command.
Examples
# Set the number of collected digits before the requesting of the calling party information to three.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all
[Sysname-cas1/0:0] ani-offset 3
Related commands
• cas
• timer
• reverse
• renew
answer enable
NOTE:
This command applies to R2 signaling only.
Use answer enable to enable the sending of answer signals before the both parties can enter a
conversation.
Use undo answer enable to restore the default.
Syntax
answer enable
undo answer enable
Default
The answer signal must be sent.
Views
R2 CAS view
Default command level
2: System level
Usage guidelines
The R2 line signaling coding schemes in some countries do not include answer signal sending. In this
case, you can use the answer enable command to enable the sending of answer signals. If the
originating side does not request answer signals, the terminating side will enter a conversation with the
originating side after a specified period.