R2511-HP MSR Router Series Voice Command Reference(V5)

111
Examples
# Configure the originating side to disable the terminating side from sending answer signals.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] undo answer enable
Related commands
• re-answer enable
• timer dl re-answer
callmode
Use callmode to configure the connection mode for an R2 call.
Use undo callmode to restore the default setting.
Syntax
callmode { segment | terminal }
undo callmode
Default
The connection mode for an R2 call is terminal.
Views
R2 CAS view
Default command level
2: System level
Parameters
segment: Specifies the connection mode for an R2 call as segment-to-segment.
terminal: Specifies the connection mode for an R2 call as terminal-to-terminal.
Examples
# Set the connection mode for an R2 call to segment.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas 1/0:0] callmode segment
cas
Use cas to enter R2 CAS view, digital E&M signaling view, or digital LGS signaling view.
Syntax
cas ts-set-number