R2511-HP MSR Router Series Voice Command Reference(V5)

112
Views
E1 interface view, T1 interface view
Default command level
2: System level
Parameters
ts-set-number: Number of a created timeslot (TS) set, in the range of 0 to 30 (for E1 interfaces) or 0 to 23
(for T1 interfaces).
Usage guidelines
You can configure signaling parameters in signaling view. The TS set number specified in this command
must already be created with the timeslot-set command. After entering a signaling view, you can
configure signaling parameters as desired. When doing that, assign the same value to the ts-set-number
argument in commands cas and timeslot-set.
Examples
# Enter the R2 CAS view of TS set 5.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 5
Related commands
• timeslot-set
• ani-offset
• reverse
• select-mode
• timer
• trunk-direction
• renew
clear-forward-ack enable
NOTE:
This command applies to R2 signaling only.
Use clear-forward-ack enable to enable the terminating side to send an acknowledgement (clear-back
signal) in response to the clear-forward signal of the originating side.
Use undo clear-forward-ack enable to disable the terminating side from responding to the clear-forward
signals with clear-back signals.
Syntax
clear-forward-ack enable
undo clear-forward-ack enable
Default
The terminating side does not send clear-back signals to acknowledge clear-forward signals.