R2511-HP MSR Router Series Voice Command Reference(V5)

120
Views
BSV BRI interface view
Default command level
2: System level
Examples
# Disable interface BSV BRI 2/0 from generating linkUp/linkDown traps.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] undo enable snmp trap updown
final-callednum enable
NOTE:
This command applies to R2 signaling only.
Use final-callednum enable to enable the originating side to send a number terminator to the terminating
side after it sends all digits of a called number. After the terminating side receives this terminator, it stops
requesting the called number.
Use undo final-callednum enable to disable the originating side from sending a number terminator to the
terminating side after it sends all digits of a called number.
Syntax
final-callednum enable
undo final-callednum enable
Default
No number terminator is sent.
Views
R2 CAS view
Default command level
2: System level
Usage guidelines
You can use the final-callednum command to accommodate to the R2 interregister signaling in some
countries where a number terminator can be sent to indicate that all digits of a called number have been
sent.
Examples
# Enable the originating side to send the number terminator signal.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] final-callednum enable
Related commands
register-value digital-end