R2511-HP MSR Router Series Voice Command Reference(V5)

122
Views
R2 CAS view
Default command level
2: System level
Usage guidelines
You can use the undo form of this command to accommodate to the R2 interregister signaling in some
countries where Group B signals is not supported or cannot be interpreted correctly.
Examples
# Adopt Group B signals to complete registers exchange.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] group-b enable
Related commands
register-value req-switch-groupb
line
Use line to configure the binding between a POTS entity and a logical voice subscriber line.
Use undo line to remove the binding.
Syntax
line slot-number:{ ts-set-number | 15 | 23 }
undo line
Default
There is no binding between a POTS entity and a logical voice subscriber line.
Views
POTS voice entity view
Default command level
2: System level
Parameters
slot-number: Number of the E1/T1 interface corresponding to a subscriber line.
ts-set-number: Number of the TS set created on the E1/T1 interface.
15: Indicates that the POTS voice entity is to be associated with an E1 voice ISDN PRI interface.
23: Indicates that the POTS voice entity is to be associated with a T1 voice ISDN PRI interface.
Usage guidelines
After configuring a target match template with the match-template command for a voice entity, you need
to associate the entity with a logical interface to indicate from which interface the traffic destined for the
target should be routed.