R2511-HP MSR Router Series Voice Command Reference(V5)

123
Examples
# Associate a POTS entity with a TS set on an E1 interface.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] line 1/0:1
Related commands
• entity
• pri-set
• timeslot-set
link-delay
Use link-delay to set the physical state change suppression interval on an E1/T1 interface.
Use undo link-delay to restore the default.
Syntax
link-delay delay-time
undo link-delay
Default
physical state change suppression is disabled on a E1/T1 interface. The system detects the physical
states of interfaces every 5 seconds. When a physical state change occurs, the system can detect the
change within 5 seconds and immediately report the change.
Views
E1/T1 interface view
Default level
2: System level
Parameters
delay-time: Sets the physical state change suppression interval in the range of 0 to 10 seconds. The value
of 0 disables physical state change suppression (which can also be disabled by using the undo
link-delay command) on an E1/T1 interface.
Usage guidelines
Suppose you set the delay-time argument to 2 for an interface. When a physical state change occurs to
the interface, the system can detect the change within 5 seconds and report the change 2 seconds after
detecting the change. In other words, the system reports the change 2 to 7 seconds after the change
occurs.
This command must be executed in controller view.
NOTE:
This command does not take effect on ports that have been administratively shut down using the shutdown
command.