R2511-HP MSR Router Series Voice Command Reference(V5)

124
Examples
# Set the physical state change suppression interval to 2 seconds on the E1/T1 interface E1 2/0, so that
the system can detect a physical state change and report the change 2 to 7 seconds after the change
occurs.
<Sysname> system-view
[Sysname] controller e1 2/0
[Sysname-E1 2/0] link-delay 2
mirror (digital voice subscriber line view)
Use mirror to mirror the PCM, RTP, or voice command data for a calling number, a time slot, or all time
slots on the digital voice subscriber line to a specified interface or destination.
Use undo mirror to remove a mirror entry or all mirror entries.
Syntax
To mirror PCM or RTP data based on a calling number, use the command:
mirror number number { pcm | { in | out | all } data } calling calling-number to { local-interface
interface-type interface-number [ mac H-H-H ] | remote-ip ip-address [ port port ] }
undo mirror [number number]
To mirror PCM data based on a time slot, use the command:
mirror number number pcm { bdsp | fdsp } channel-number to { local-interface interface-type
interface-number [ mac H-H-H ] | remote-ip ip-address [ port port ] }
undo mirror [number number]
To mirror RTP or command data on all time slots, use the command:
mirror number number { in | out | all } { command | data } to { local-interface interface-type
interface-number [ mac H-H-H ] | re
mote-ip ip-address [ port port ] }
undo mirror [number number]
Default
No traffic is mirrored.
Views
Digital voice subscriber line view
Default level
2: System level
Parameters
number number: Specifies a mirror entry number in the range of 1 to 64.
pcm: Mirrors PCM data.
in: Mirrors inbound RTP or command data.
out: Mirrors outbound RTP or command data.
all: Mirrors bidirectional RTP or command data.
data: Mirrors RTP data.
command: Mirrors voice command data.