R2511-HP MSR Router Series Voice Command Reference(V5)

126
Default command level
2: System level
Parameters
zone-name: Country or region name. The argument can be one of the following values:
• argentina: Uses Argentinean R2 signaling standard.
• australia: Uses Australian R2 signaling standard.
• bengal: Uses Bengalese R2 signaling standard.
• brazil: Uses Brazilian R2 signaling standard.
• china: Uses Chinese R2 signaling standard.
• custom: Uses customized R2 signaling standard.
• hongkong: Uses Hongkong R2 signaling standard.
• india: Uses Indian R2 signaling standard.
• indonesia: Uses Indonesian R2 signaling standard.
• itu-t: Uses ITU-T R2 signaling standard.
• korea: Uses Korean R2 signaling standard.
• malaysia: Uses Malaysian R2 signaling standard.
• mexico: Uses Mexican R2 signaling standard.
• newzealand: Uses New Zealand R2 signaling standard.
• singapore: Uses Singaporean R2 signaling standard.
• thailand: Uses Thai R2 signaling standard.
default-standard: Initializes R2 signaling parameters such as values of the force-metering command
based on national R2 signaling variants.
Usage guidelines
The R2 signaling standards implemented in different countries and regions might vary. They are called
ITU variants. To accommodate to the R2 signaling in a country or region, you can use the mode
command. The system can automatically select the appropriate subscriber line state, service category,
metering signal, and signal values of C and D bits.
The device supports Brazil, Mexico, Argentina, India, New Zealand, Thailand, Bengal, South Korea,
Hongkong, Indonesia, and other ITU-T variants.
With the default-standard keyword configured, the system initializes the subscriber line status, service
type, metering signal and C and D signaling bits and other parameters depending on the default settings
of configured national R2 signaling variants.
If the custom keyword is configured, you can customize specific signaling exchange procedures and
signal values in R2 signaling to accommodate to countries.
Examples
# Adopt Hongkong default R2 signaling.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] mode hongkong default-standard