R2511-HP MSR Router Series Voice Command Reference(V5)

129
Default
The QSIG tunneling function is disabled.
Views
Digital voice subscriber line view
Default command level
2: System level
Examples
# Enable the QSIG tunneling function.
<Sysname> system-view
[Sysname] subscriber-line 1/0:15
[Sysname-subscriber-line1/1:15] qsig-tunnel enable
re-answer enable
NOTE:
This command applies to R2 signaling only.
Use re-answer enable to enable the originating side to support re-answer signal processing.
Use undo re-answer enable to restore the default.
Syntax
re-answer enable
undo re-answer enable
Default
The originating side does not process re-answer signals.
Views
R2 CAS view
Default command level
2: System level
Usage guidelines
In some countries, re-answer process is needed in R2 signaling. When the terminating side sends a
clear-back signal, the originating side does not release the line right away, but maintains the call state
instead. If it receives the re-answer signal from the terminating side within a specified time, it continues
the call; otherwise, it disconnects the call upon timeout.
Examples
# Enable the originating side to process re-answer signals.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas 1/0:0] re-answer enable