R2511-HP MSR Router Series Voice Command Reference(V5)

130
Related commands
• answer enable
• timer dl re-answer
register-value
NOTE:
This command applies to R2 signaling only.
Use register-value to configure R2 register signal values.
Use undo register-value to restore the defaults.
Syntax
register-value { billingcategory | callcreate-in-groupa | callingcategory | congestion |
demand-refused | digit-end | nullnum | req-billingcategory | req-callednum-and-switchgroupa |
req-callingcategory | req- currentcallednum-in-groupc | req-currentdigit | req-
firstcallednum-in-groupc | req-firstcallingnum | req-firstdigit | req-lastfirstdigit | req-lastseconddigit |
req-lastthirddigit | req-nextcallednum | req-nextcallingnum | req-switch-groupb |
subscriber-abnormal |subscriber-busy | subscriber-charge |subscriber-idle } value
undo register-value { billingcategory | callcreate-in-groupa | callingcategory | congestion |
demand-refused | digit-end | nullnum | req-billingcategory | req-callednum-and-switchgroupa |
req-callingcategory | req- currentcallednum-in-groupc | req-currentdigit | req-
firstcallednum-in-groupc | req-firstcallingnum | req-firstdigit | req-lastfirstdigit | req-lastseconddigit |
req-lastthirddigit | req-nextcallednum | req-nextcallingnum | req-switch-groupb |
subscriber-abnormal |subsc
riber-busy | subscriber-charge |subscriber-idle }
Views
R2 CAS view
Default command level
2: System level
Parameters
billingcategory value: Specifies the billing category value in the range of 1 to 16. It configures the KA
signal in R2 signaling. The KA signal is sent by the originating side forward to the originating toll office
or originating international exchange to indicate calling category. The signal provides two types of
information for this call connection: billing category (regular, immediate, or toll free) and subscriber level
(with or without priority).
callcreate-in-groupa value: Specifies the direct call setup signal value in the range of 1 to 16.
callingcategory value: Specifies the calling category signal value in the range of 1 to 16. It configures the
R2 KD signal. It functions to identify whether break-in and forced- release can be implemented by or on
the calling party.
congestion value: Specifies the congestion signal value in the range of 1 to 16.
demand-refused value: Specifies the request-refused signal value in the range of 1 to 16.
digit-end value: Specifies the digit-end signal value in the range of 1 to 16.
nullnum value: Specifies the null number signal value in the range of 1 to 16.
req-billingcategory value: Specifies the send billing category signal value in the range of 1 to 16.