R2511-HP MSR Router Series Voice Command Reference(V5)

131
req-callednum-and-switchgroupa value: Specifies the send last digit and changeover to Group A signal
value in the range of 1 to 16.
req-callingcategory value: Specifies the send calling category signal value in the range of 1 to 16.
req-currentcallednum-in-groupc value: Specifies the send current called number signal in Group C state,
in the range of 1 to 16.
req-currentdigit value: Specifies the send current digit signal value in the range of 1 to 16.
req-firstcallednum-in-groupc value: Specifies the send first digit signal value in Group C state, in the
range of 1 to 16.
req-firstcallingnum value: Specifies the send calling number signal value in the range of 1 to 16.
req-firstdigit value: Specifies the send first digit signal value in the range of 1 to 16.
req-lastfirstdigit value: Specifies the send last digit signal value in the range of 1 to 16.
req-lastseconddigit value: Specifies the send last second digits signal value in the range of 1 to 16.
req-lastthirddigit value: Specifies the send last three digits signal value in the range of 1 to 16.
req-nextcallednum value: Specifies the send next called number signal value in the range of 1 to 16.
req-nextcallingnum value: Specifies the send next calling number signal value in the range of 1 to 16.
req-switch-groupb value: Specifies the changeover to Group B signal value in the range of 1 to 16.
subscriber-abnormal value: Specifies the subscriber's line abnormal signal value in the range of 1 to 16.
subscriber-busy value: Specifies the subscriber's line busy signal value in the range of 1 to 16.
subscriber-charge value: Specifies the charge value when the subscriber's line is idle, in the range of 1
to 16.
subscriber-idle value: Specifies the subscriber's line idle value in the range of 1 to 16. It configures the
R2 KB signal used for describing the called subscriber's line status, for example, whether the line is idle.
It acknowledges and controls call connection. If your router is connected to a PBX, change the KB value
on the router to that used on the PBX, in case different KB values are used. If your router is connected to
another router, you only need to make sure that the same KB signal value is used between them.
The defaults vary by national variant.
Usage guidelines
You can set a signal value to 16 to indicate that the signal function does not exist. For example, if the send
last digit signal is not available in a national R2 signaling variant, you can set the value for
req-lastfirstdigit to 16.
The purpose of the register-value command is to assign values to signals requesting responses from the
remote end. For example, after you configure the register-value callingcategory command, the
terminating side sends the send calling category signal with the specified value to the originating side for
the calling category.
As some national register signal coding schemes might not support all the register signals mentioned in
this section, HP recommends that you use defaults unless necessary. For example, the ITU-T
recommendation is available with the send calling category signal (the callingcategory keyword) but not
the send billing category (billingcategory) signal.
Examples
# Request the originating side to send calling category by configuring a backward signal (signal value
7).