R2511-HP MSR Router Series Voice Command Reference(V5)

134
Syntax
seizure-ack enable
undo seizure-ack enable
Default
The originating side requires the terminating side to send seizure acknowledgement signal.
Views
R2 CAS view
Default command level
2: System level
Usage guidelines
Generally, the terminating side acknowledges received seizure signals. The R2 line signaling coding
schemes in some countries however do not require the terminating side to do this. To accommodate to
these schemes, you can configure the undo seizure-ack enable command, allowing the terminating side
not to acknowledge received seizure signals.
Examples
# Disable the terminating side from sending seizure acknowledgement signals.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] undo seizure-ack enable
Related commands
timer dl seizure
select-mode
Use select-mode to set the E1 trunk routing mode.
Use undo select-mode to restore the default.
Syntax
select-mode { max | maxpoll | min | minpoll }
undo select-mode
Default
The timeslot with the smallest number is selected.
Views
R2 signaling view
Default command level
2: System level
Parameters
max: Selects the timeslot with the greatest number from available timeslots.