R2511-HP MSR Router Series Voice Command Reference(V5)

137
special-character
NOTE:
This command applies to R2 signaling only.
Use special-character to configure the special characters acceptable during register signal exchange.
Use undo special-character to remove the configured special characters.
Syntax
special-character character number
undo special-character character number
Default
No special characters are configured.
Views
R2 CAS view
Default command level
2: System level
Parameters
character: Special character, which can be a pound sign (#) or asterisk (*), A, B, C, or D.
number: Code of register signal in the range of 11 to 16.
Usage guidelines
You can use this command to accommodate to some national R2 signaling variants where Group I
forward signals can represent special characters such as pound signs (#) and asterisks (*) in addition to
digits.
The mappings between special characters and signals must be unique. You cannot map a special
character to different signals or different special characters to the same signal.
Examples
# Assign the pound sign (#) the register signal code 11.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] special-character # 11
subscriber-line
Use subscriber-line to enter E1/T1 voice subscriber line view.
Syntax
subscriber-line slot-number:{ ts-set-number | 15 | 23 }
Views
Voice view