R2511-HP MSR Router Series Voice Command Reference(V5)

141
Syntax
timer dtmf time
undo timer dtmf
Default
The delay is 50 milliseconds.
Views
R2 CAS view
Default command level
2: System level
Parameters
time: Delay before sending a DTMF signal in milliseconds, in the range of 50 to 10000.
Usage guidelines
Before you can configure this command, you must configure the dtmf enable command.
Generally, the originating side starts sending DTMF signals immediately after receiving a line seizure
acknowledgement signal. Sometimes, however, you might need to introduce a delay to accommodate to
the digit collection process on the remote PBX.
Examples
# Configure the R2 signaling to start sending DTMF signals 800 milliseconds later after receiving a
seizure acknowledgement signal.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] dtmf enable
[Sysname-cas1/0:0] timer dtmf 800
Related commands
dtmf enable
timer hold
Use timer hold to set the interval for sending keepalive packets.
Use undo timer hold to restore the default.
Syntax
timer hold seconds
undo timer hold
Default
The keepalive interval is 10 seconds.
Views
BSV BRI interface view